<br><font size=2 face="sans-serif">Hello all,</font>
<br>
<br><font size=2 face="sans-serif">We finally managed to convert the in-process-workpiece
in UGS cad system into STEP203 format. I have not yet checked the file
in detail, but I assume it could be used for preparing roughing tool paths
and as "raw material" when preparing the finishing paths. (The
piece of software that solved this was "Imageware" by UGS).</font>
<br>
<br><font size=2 face="sans-serif">For you involved in this part of the
demo, please check the attached model to see if it could be used for the
above purpose or if it needs to be modified.</font>
<br><font size=2 face="sans-serif">Let me know if you encounter any problems.</font>
<br><font size=2 face="sans-serif">Best Regards,</font>
<br><font size=2 face="sans-serif">Bengt</font>
<br>
<br>
<br>
<br><font size=1 face="Verdana">Bengt Olsson<br>
Sandvik Tooling Sverige AB, TTLP<br>
Office Phone: +46 26-266691<br>
<br>
</font><font size=2 face="sans-serif"><br>
</font><font size=1 color=#808080 face="Verdana">This e-mail is confidential
and it is intended only for the addressees. Any review, dissemination,
distribution, or copying of this message by persons or entities other than
the intended recipient is prohibited. If you have received this e-mail
in error, kindly notify us immediately by telephone or e-mail and delete
the message from your system. The sender does not accept liability for
any errors or omissions in the contents of this message which may arise
as a result of the e-mail transmission.<br>
</font>