[step-manufacturing] Another try: Can we switch from Wednesday to Thursday?

[Bengt Olsson]

Tuesday works good for me as well
Regards
Bengt

> On 4 Oct 2024, at 21:22, Martin Hardwick <hardwick at steptools.com> wrote:
>
> There are conflicts on Thursday so we will try the same time on Tuesday (one day before the original).
>
> Again, email me if this will prevent you from joining.
>
> Tuesday, October 8 from 9:30AM to 10:30AM Eastern USA time.
>
> Martin
>
>> On 10/4/2024 11:38 AM, Martin Hardwick wrote:
>> All,
>>
>> There is a conflict between the WG15 meeting on Wednesday, and a JWG21 meeting on Smart Manufacturing in Stockholm (the one near Norway).
>>
>> In view of the proximity to the location of our upcoming meeting would it be OK if we moved the planning meeting to Thursday (one day later).
>>
>> Please reply by e-mail if your were planning to join the planning meeting but cannot manage the proposed new time slot.
>>
>> Thursday, October 10 from 9:30AM to 10:30AM Eastern USA time.
>>
>> Martin
>>
> --
> Martin Hardwick
> President STEP Tools, Inc.
> Cell: 518 253-0596
> Software for worldwide manufacturing
> "There are billions of STEP files and millions of STEP-NC files"
>
> _______________________________________________
> step-manufacturing mailing list
> step-manufacturing at steptools.com
> http://lists.steptools.com/mailman/listinfo/step-manufacturing
This e-mail is confidential and it is intended only for the addressees. Any review, dissemination, distribution, or copying of this message by persons or entities other than the intended recipient is prohibited. If you have received this e-mail in error, kindly notify us immediately by telephone or e-mail and delete the message from your system. The sender does not accept liability for any errors or omissions in the contents of this message which may arise as a result of the e-mail transmission.