[step-manufacturing] Minutes of February 4th conference call

[Martin Hardwick]

Attendees
--------------
Martin Hardwick, STEP Tools, USA
Julie Huang, Sandvik Sweden
Bengt Olsson, Sandvik, Sweden
Mikael Hedlind, Scania, Sweden
David Odendahl, Boeing, USA
Robert Erickson, Pratt & Whitney, USA
Vincent Marchetti, Ameritech, USA
Ted Driggs, Okuma, USA
Larry Maggiano, Mitutoyo, USA
Zhigang Wang, Okuma. USA
Roger Hart, Siemens, USA
Dan Finke, Penn State, USA

We reviewed three scenarios for CAM data exchange in preparation for the 
face to face meeting next week.
ftp://www.steptools.com/private/CAM_exchange/Cycle_5/CAM_Data_Scenarios.pptx

We agreed to focus on the process monitoring scenario.

1. Load process and cutting tool data
2. Validate process with (as-measured) dimensions of the tools
3. Start process and track the machining at a very fine level of detail 
(using Process Monitoring service)
4. Compare the three results (as-designed with AP242 GD&T, as-monitored 
with tight tolerance simulation, as-machined and measured on a CMM)
5. Generate better solutions (using NC Generation service)
6. Repeat

A recording of this conference calls is on the web site at the address 
below:
ftp://www.steptools.com/private/CAM_exchange/Cycle_5/stepmanuf_telecon_20150204.wmv

The next conference call is planned for Wednesday February 18th.

Martin Hardwick
Team Leader ISO STEP-Manufacturing